No More Headaches! Our Kerf Tool is Available Here. Recently Revised 4/2022 !

Laser Light designs

Laser Light designsLaser Light designsLaser Light designs
  • Home
  • Kerf Tool
  • Tests
    • Masking
    • Clear Coats
  • How To's
    • Resizing Videos
    • Kerf Tool System
    • Using a Jig
    • Design Tutorials
    • Proofgrade Settings
    • Understanding Alignment
    • Inconsistent Cuts
  • LASER 101
    • Before you buy a Laser
    • Just got a Laser
    • "Must-Have" Links
    • Laser Files
    • Glowforge FAQ
  • CNC 101
    • CNC Training
  • Our Etsy
  • More
    • Home
    • Kerf Tool
    • Tests
      • Masking
      • Clear Coats
    • How To's
      • Resizing Videos
      • Kerf Tool System
      • Using a Jig
      • Design Tutorials
      • Proofgrade Settings
      • Understanding Alignment
      • Inconsistent Cuts
    • LASER 101
      • Before you buy a Laser
      • Just got a Laser
      • "Must-Have" Links
      • Laser Files
      • Glowforge FAQ
    • CNC 101
      • CNC Training
    • Our Etsy

Laser Light designs

Laser Light designsLaser Light designsLaser Light designs
  • Home
  • Kerf Tool
  • Tests
  • How To's
  • LASER 101
  • CNC 101
  • Our Etsy

Hold Down Pins

Hold Down Pins

Hold Down Pins

Hold Down Pins

Use this link for the free download. There are three versions of the pin to accommodate a few different uses ! Use 1/8" material and remove masking before use.

Small Pin

Hold Down Pins

Hold Down Pins

This pin is your most commonly used. Increased height allows for easy inserting and for when you need to pull it out.  Use 1/8" material and remove masking before use. 

Combo Pin

Combo Pin

Combo Pin

We found that sometimes we wished only one side was extended - maybe for when you are using it between two independent pieces on the crumb tray, but you want a short side where it may be close to a cut line.  Use 1/8" material and remove masking before use. 

Wide Pin

Combo Pin

Combo Pin

This extended width pin is excellent for when you are using it between two independent pieces on the crumb tray, and not cut lines are near. This is our favorite pin!  Use 1/8" material and remove masking before use. 

Looking for more?

Back to tutorials

Subscribe

Subscribe for instant notification of discounts, designs, tutorials, tips & tricks !

Copyright © 2022 Laser Light Designs - All Rights Reserved.

Powered by GoDaddy

  • Home
  • Kerf Tool
  • Our Etsy